gateway-control-ui

Step-by-step guide to log into the OpenClaw Control UI, enter gateway token, approve device pairing, and verify connection

Gateway Control UI Login & Pairing

Use when a user needs to access the OpenClaw Gateway Control UI, authenticate, pair a device, and confirm connectivity.

Prerequisites

• OpenClaw gateway running (openclaw status)
• Control UI URL configured in gateway.controlUi.allowedOrigins
• Gateway token available in config (/data/.openclaw/openclaw.json)
• Device pairing approval (CLI)

Steps

1. Open Control UI

• URL: use your configured OpenClaw service URL (from gateway.controlUi.allowedOrigins)
• HTTP Basic Auth:
  • Username: use your SERVICE_USER_OPENCLAW value
  • Password: use your SERVICE_PASSWORD_OPENCLAW value
• Optional embedded form:
  • https://<user>:<pass>@<your-openclaw-domain>/

2. Get Gateway Token

cat /data/.openclaw/openclaw.json | grep -A 2 '"token"'

Token is under:

"gateway": { "auth": { "token": "YOUR_TOKEN_HERE" } }

3. Enter Token in UI

• On Overview page, click Gateway Token field
• Paste token
• Click Connect

4. Approve Pairing (CLI)

openclaw devices list
openclaw devices approve <requestId>

5. Verify Success

• In Control UI: status shows green “OK” and dashboard loads
• CLI:

  openclaw status --deep
  

  Check Gateway → reachable and channels show OK.

Troubleshooting

• Page stays on form? WebSocket URL may need to be filled (usually left blank for remote)
• Pairing fails? Run openclaw devices list again to see pending requests
• Token invalid? Check /data/.openclaw/openclaw.json for correct value